0087 Powder filling equipment Preventing bridging in mobile raw material hoppers
Hopper for powder filling equipment and auxiliary equipment. Measures have been implemented to address bridging in a mobile small raw material hopper equipped with casters.
Initially, in preparation for the bridge at the discharge section, two Bro-Disk Minis with a diameter of 50 mm were installed at the upper part of the discharge section (the area where the bridge was anticipated). However, when it actually operated, even though there was no clogging in that area, it became a rat hole state with holes only in that part, which led to your consultation. As a result of our consultation, since it was very fine powder and adhesion was also anticipated, we installed a slightly larger number of units as follows. ... Bro-Disk is an inexpensive device. Even if you install many of them, the cost-effectiveness is sufficient! Of course, it has started to operate well. Even if you have experience in bridge countermeasures, if you have any concerns or worries, please feel free to contact us. We believe we have many experiences we can share with you. This time, we submitted the mill sheet for the shaft part and the food sanitation law compliance certificate for the elastic disk. If you need these documents, we can prepare them immediately, so please feel free to request them. If you are struggling with powder and granular materials, please consult our company. We have published many implementation examples on our website. You can check them from the link below.
- Company：ミナギ
- Price：Other
